|01-21-2017 07:30 PM|
|jbjs40||I have a 2015 se automatic. I know, I know, already took it in and had it reprogrammed. Not so bad after that though so anyways.... I'm getting an ST next year! Did the resonator thing at the bottom of the air box just pop out or what? I had the cover removed but wife didn't like the growl. It's like a lion's roar but from a kitten. SO I kind of like the balls to back up the roar and decided to put the cover back on. I'm adding a free flow AEM air filter and plan on removing that thing your holding in your hand (resonator?) I'm going to seal or mesh the opening though. So step by step how did you get the bottom of the air box out and the resonator? I already deleted the snorkel and formed a air inlet ram for the opening where the snorkel was. I will keep you posted on progress.|
|03-14-2016 09:28 PM|
|Mrlandy||OK, All done. Made snorkel brace and grille piece from box aluminum. Heat wrapped snorkel. Now I need to modify the 2 tiny air tubes that are part of stock air box.|
|03-14-2016 03:23 PM|
Why can't you post pics of the hood up with the snorkel installed?
Water intrusion is not an issue needing to be dealt with, btw. Short of driving into a tsunami, not enough water will be able to get into that small of an opening to cause an issue.
|03-14-2016 09:20 AM|
I printed a second one because I wanted the exposed snorkel to angle (down) lower for water drain. That's why it looks tipped forward. There are drain holes for water right under the opening. I have half of the grill dedicated to the new snorkel in front of vents, no cutting, of the shroud, just enlarged enough to fit the snorkel through. Doesn't get in the way of the active shutter and no overheating even though half of the grill is dedicated to the huge snorkel.
I noted .3 more miles per gallon, no biggie. It does seem to have more constant acceleration without the bog down at takeoff.
you can see from the opening (above) cut where the air box lines up with snorkel (below)
|03-14-2016 02:57 AM|
Looks like the same size as the Velossa Tech Big Mouth-
|03-13-2016 04:33 PM|
|Mrlandy||Yes, file was tweaked a few times before I printed. Mouth is 3x bigger|
|03-13-2016 03:04 PM|
|03-13-2016 01:41 PM|
|03-12-2016 07:26 PM|
|03-08-2016 02:40 PM|
You can get it printed online from places like this:
3D Printing Price Check - compare 3D printing prices for FDM, SLS, DMLS, Polyjet, metals, and more from eight vendors (and counting)
Upload the file (make sure you check it hasn't been resized) and it will give you best prices based on material. It will be at your door in 3 days.
$105 (free ship) any color from here (ABS): https://www.makexyz.com
|This thread has more than 10 replies. Click here to review the whole thread.|