|11-30-2013 05:25 PM|
First of all I'd like to thank Exsodius for healing my headache with that doorlock problem that i have almost year and a half. Now my door is locking and unlocking like new.
Also I'd like to give a tip, before i did like exsodius said, if you don't have time to remove the lock mechanism from the door and clean and lubricate it, just spray into the side of the two front doors lock mechanism a lot of wd-40 and it will flow underneath the door, shut the door and lock and unlock several times, and it will work. (this is just temporally until you have the time to take out the mechanism from the door and clean it good)
I'm new to this site so cheers to everyone and this thread made me to register myself.
|10-16-2013 05:09 PM|
I noticed the central locking problem driving my girlfriends 1999 Focus for the first time - when the doors unlocked a mile down the road!
Removing the screw and spraying WD40 into the hole for 20 seconds seems to have done the trick, thanks exsodius!
|03-04-2013 02:29 PM|
When using the key my central locking is working fine. But, when using the remote fob it does not. I've tried to reprogram the key but after the chime sound (which indicates that the programming mode is ON) nothing happens when I press/hold one of the fob switches. I have also tried replacing the battery and the micro switches in the fob but still the same. Then I've tried to program another fob (borrowed from my uncle, same car, same fob type) but still the same.
Any idea how to solve this issue? Central locking module is 98AG 15k600 DB, CL, RF. How to ceck if the module is OK?
My car is focus 1.8tddi 1999.
|01-10-2013 11:34 AM|
|01-10-2013 12:11 AM|
|01-09-2013 08:03 PM|
if so how do i know which is the correct torx nut?
|12-17-2012 05:00 AM|
|Bønna||This sounds like a similar syncronising problem as discussed by us in the thread. Try spraying as described. It might lube the micro switch, and give correct locking state from all locks.|
|06-13-2010 09:29 AM|
my remote central locking isnt working... well actually it will lock the passengers side dor but it immediately unlocks again, so wont lock.
If i put the key in the drivers door it will lock and unlock.
if i put the key in the passenger door it locks then straigh away bounces unlocked again.
is the idea of spraying wd-40 likey to work for me to or do i have a different fault??
|06-12-2010 12:47 PM|
Another fix here! I was getting intermittent locking/unlocking of my central locking, tried loads of things and now tried blasting down that hole where the bottom screw goes and bad a bing its working every time!!
Cheers for the tip!
|04-06-2010 05:23 AM|
Exsodius, your last fix is just incredible ! Thanks a lot !
I did what you described on the front doors, and nothing happened. Then I gave the rear doors a real spray, and while I sprayed the locks started to kick !
Now everything works fine for the first time in 5 years ! Fantastic
|This thread has more than 10 replies. Click here to review the whole thread.|