|11-14-2012 01:45 AM|
My stuff says.......................
go to 37 ft.lbs.
back off all 1/2 turn
go back to 37 again
go 1/4 turn more all
then go another 1/4 turn all again.
9 3 1 5 7
8 6 2 4 10
|11-14-2012 01:29 AM|
It is routine for gasket makers and others to now suggest that ALL stressed bolts like head bolts should be changed, it is more of a guarantee their part will be successful. Besides that it sells more parts...............I notice that Felpro now calls for new bolts on engines I know for a fact don't need them.
The way you tell-
if final tightening is worded as a DEGREE OF ANGLE such as 90 degrees or 45 degrees or whatever, then yes, you need to change the bolts.
if final tighten is a TORQUE, or 44 ft.lbs. or 65 ft.lbs., etc. then bolts are reuseable provided nothing has happened to them that would warrant their being changed.
SPI seems to call for a last tighten of 1/4 turn so that is 90 degree angle, so yes, bolts need to change. They get stretched out of shape at first tightening, you can blow head gasket by using them again since they are already internally yielded (TTY, or 'torque to yield', the type of bolt).
|11-12-2012 12:36 PM|
|PuntaGorda||I'm rebuilding a SOHC 2.0 SPI and have less than complete faith in the specifications provided by our trusty friends at Fel-Pro. Could I get a few second opinions on the torque specifications and end sequence for the Head Bolts? I currently have them all at 44 ft/lbs and will hold sequence until a consensus of the SPI gods has been made. Thank you.|
|10-05-2009 10:02 PM|
The SOHC are one time use, $24 - Felpro. The DOHC are rated for two uses before replacement - aren't they?
|10-05-2009 07:33 PM|
|whynotthinkwhynot||Buy new bolts, if you think you're going to be keeping that car and engine until the doors fall off, do some research and see if ARP makes bolts for the engine. Those shouldn't stretch.|
|10-05-2009 07:06 PM|
|trailbikerider||They're called TTY Bolts (Torque-To-Yield) and yes, they're only good once.|
|10-05-2009 06:39 PM|
|mikebontoft||did you ever get that head replaced btw? and yes IIRC bolts are one time one use unfortunately.|
|10-05-2009 06:37 PM|
According to the Haynes manual-"....the bolts are the stretch type that must be replaced with new ones whenever they're removed."
I replaced mine when I had the head resurfaced and valve job done.
|10-04-2009 08:18 PM|
Spi head gasket
I suspect my head gasket is trash can I reuse the head studs I thought I read u could on a focus but I searched to no avail.
Posted via FF Mobile