Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (
-   MK1 Focus (
-   -   Rear Seat Swap (

Wagone 09-16-2012 11:51 AM

Rear Seat Swap
I have an 03 wagon. I found some rear seats with head rests from an 00 or 01 zx3. The latch point of the zx3 seats is about one inch inboard vs wagoon seats. Anyone have a workaround? Thanks.

Wagone 09-16-2012 06:15 PM

Update. Seats look the same but wagon seats backs are one inch wider and latch is off by this amount. Either i move the latches inboard one inch with spacers, or go back to stock. Too tired to decide now.

Wagone 09-17-2012 07:29 PM

Pulling back cover on wagon seat found out the frame has a metal section with holes to install three head rests, two sides and one in the middle, lets hear it for world cars. The head rest moves in a black tube that snaps into these holes. I would bet the front tube and rears are the same. The spacing of the rear head rest rods is narrower (12 cm) than the fronts (15 mm) so a head rest swap wont work. I would bet anyone could snag some JY tubes, and pop them into their seats, after cutting a small hole. I wonder in other Ford product head rests have the same spacing as the backs . Both F and R have 12 mm dia posts, the R are smooth, and the fronts are notched.

Want to make the car safer for passengers.

I would post pictures, but need to get a link to " FF picture for dummies" first.

Wagone 09-24-2012 09:26 PM

Popped the tubes in the rear seat. Just had to lift the connection on the bottom of the seat, run a screw driver up and through the holes (they angle forward) then cut the fabric. They snap in.

Getting the tubes out from a JY seat needs access to the upper portion. Push in the tab and tap the tube up with a hammer ligthly.

Wagone 10-01-2012 10:13 PM

This is the ZX3 factory hole position.

Wagone 10-01-2012 10:15 PM

One set of tubes is tight. May have missed slighlty with tube depth. Hard to see when the notch grabs. May have over driven it.

All times are GMT -5. The time now is 05:17 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.