Focus Fanatics Forum banner

Reaction score
20

Marketplace Rating
(5.0 - 25 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews Media About

  • · Registered
    Joined
    ·
    268 Posts
    Hey Tim when you get a chance tried texting you. I see you've been offline for a while now hope to hear from you but would really like to get the angles on my piping kit fixed so my fog light can be re installed and so my TB angle can be less drastic. Thanks again.

    Jake

    · Registered
    Joined
    ·
    2,152 Posts
    Hey Tim, I have a turbo header. I would like to send you pics with measurements in the picture. I may wanna modify it but also have u make a piping set up for it.

    · Fins Up!
    Joined
    ·
    5,596 Posts
    no you dont need to turn them both off. you can turn off the rear o2 which only reads converter function. primary o2 will still be used to trim fuel in closed loop when cruising or idling and just like factory it will be shut off and go into open loop under hard throttle

    · Registered
    Joined
    ·
    1,117 Posts
    Hey turbo turtle I have a q? Do u know when u turbo ur car u have to turn off both o2 sensors?

    · Registered
    Joined
    ·
    418 Posts
    One more thing, I'm thinking that my slave cylinder has decided to take a dump on me. The clutch engages almost immediately coming off of the pedal and between gears you have to take it to the floor. So, my question is, how hard is it to remove the transmission in the driveway? I plan to go ahead and swap the clutch and flywheel while I have it all apart since the car has 118,xxx miles on it. More than likely an all day project or would I be better off taking it to a shop? Thanks in advance!!!

    · Registered
    Joined
    ·
    418 Posts
    Needing some insight...I replaced the stock 110A alternator with a 200A and I need a shorter belt since this 200A has an overdrive pulley. I have done a little research and found that the stock belt is 84.25". What would I need to measure to figure out what length is best? SummitRacing.com has an 82.2" and an 82.7" that they sell. Any help would be much appreciated!!!

    · Registered
    Joined
    ·
    418 Posts
    Hey Tim, I was wondering how difficult it would be for me to remove this engine in the driveway...anything special that I need besides a cherry picker? Thanks, Bub

    · Registered
    Joined
    ·
    418 Posts
    Hey Tim, this is Evan...it's been a while! How are things going? I see the STi running around town occasionally. Anyway, I was wondering if you might have any random Focus parts laying around. I recently acquired an '02 ZX3 and it needs a few parts and pieces...Thanks!!

    · Registered
    Joined
    ·
    292 Posts
    Hi, i bought your turbo a little while back. I have almost all my stuff to get the build going. I was just looking at the oil return line locations that other people use. I was curious as to why no one uses the timing plug in the block? Thanks for your help.
    matt
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top