Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (
-   General Technical Chat (
-   -   lamin x issues (

1slofofo 03-21-2013 10:35 AM

lamin x issues
So I got some yellow Laminx for Christmas. Put it on and now my left fog light has a red spot in the middle. Is it overheating or something?

rambleon84 03-21-2013 12:06 PM

is the red spot on the lens/film or showing red on the output, or both?

lamin-x shouldnt be affected by the heat of a normal fog light too much, lots of people use it.

1slofofo 03-21-2013 01:54 PM

It's right in the center, here's a picture of how it looks:

wacky 03-21-2013 02:00 PM

you should contact them directly - they have a 5-year warranty on their products i believe.

zx5fanatic 03-21-2013 02:09 PM

Did you wash your lenses with something other than soap and water before installing the films? Maybe a chemical from one of the cleaning products is slowly reacting with the film?

1slofofo 03-21-2013 02:16 PM

I used straight water, but I think that week I had a car wash, because I remember it being very clean.

1slofofo 03-21-2013 02:50 PM

Okay, so I got them off to make sure the fog light are fine, and here's the results:

Lamin-x sheet has the red spot, looks like it was burned or something. Very dirty, but you can see the red dot/stain

Fog lights little hazy (I run them plenty) but no visible damage.

Unaffected one:

One that had the red stained lamin-x:

Mr.Bergner 03-21-2013 03:49 PM

Any aftermarket bulbs?

1slofofo 03-21-2013 03:53 PM

Stock, OEM. But I don't think they're very well insulated. They're very loose as it is. I'm not blaming Lamin-X, I intend to get more and try installing them with the fog lights off the car, instead of still on.

All times are GMT -5. The time now is 07:27 PM.

Search Engine Optimization by vBSEO 3.6.1