I recently did the svt header swap and the only major problem i had with clearance was this line that is touching the cat. I believe that is the rack. Is this line different on the svt's? I know now this is where my leak is coming from. I tried looking at tousley's parts diagram, but I cannot find the name of this part to order one. Do you know what it is called? Thanks peeps in adavance!!!
It's a hard pressure line and is the same as far as I know to the normal zetec rack. I'm leaking at the same spot after I broke a motor mount and whacked the crap out of it. I think it only comes on the rack and is not a separate part to order but I'm not too sure on that.
02-22-2013 05:16 AM
hey how's it going? thanks man haha it's like we all go through the same thing, but man that would suck if you can't get that part separate.
02-22-2013 05:27 AM
Yea, I haven't tried fixing it yet either, hopefully it's easily fixable problem.
04-23-2013 03:18 AM
hey guys I couldn't find it new so I just been pulling it from the pick and pull. I have gone through four of these as temporary fixes. I can't seem to figure out why it's like this. To recap I did the svt header conversion with the svt cat and flex on a sedan. The center pressure line the goes from the rack and back into the rack keeps touching the cat. I eventually want to get an orp as I know it won't touch that line. Has anyone with a sedan experienced this?? I really don't mind changing it every two weeks, but I think they are running out of focuses at the yard lol..
04-23-2013 03:28 AM
Your header could be bent which would cause it to be too close to the rack?
04-23-2013 03:35 AM
The hard pressure line that comes off the pump? On mine which was a SPI then swapped to a zetec the line from the pump isn't like that it just slides into the rack and it has a cover to slip over it and you bolt the cover to the rack. The cover holds the line in place.
04-23-2013 03:46 AM
no way I hope not. I really can't tell tho it doesn't look like it, but I also know that on the cat it's not connected to a bracket I wonder if I can find one if that would help or I was thinking of cutting that line and and somehow with an elbow fitting moving it out the way. I don't know man I really love this header just trying to figure something that will make it last until I can get an orp.
04-23-2013 03:48 AM
no it's the one on the rack. It comes off the rack where all the other lines connect and then connects back into the rack in the middle also has a u shape