Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (
-   General Technical Chat (
-   -   Where to buy Door seals at??? (

kcw12 12-04-2011 04:55 PM

Where to buy Door seals at???
I searched the forums but didn't find what I was looking for!

I have a 2001 Focus Wagon, and the passenger side door is leaking at the door seal. (I see a hole through it)

I was wondering where is the best/cheapest place to get the seal so i can replace it?


sailor 12-04-2011 07:10 PM

Best replacement is the "Dealer" part, & cheapest is through our Focus internet dealer sources of Hilbisch or Tousley.

if you're near the Carolinas, it would be Hilbisch, Since you're closer to Tousley in Minneapolis, I'd recommend them - since I've got good advice & cheap parts from them myself...

"unobtanium" is often avail. through Steele rubber products for ALL older or "collector" cars...

kyle9563 03-19-2013 04:21 PM

What kind of weathstripping do you buy? i have a 2000 focus with a similar problem and i cant find which shape or kind to buy

sailor 03-19-2013 08:05 PM

IF it's not avail. from Ford, MANY shapes & sizes are avail. at an auto parts store like NAPA.

Take a sample with you, or draw a diagram of what it would look like from the side (as in a cross section view) plus a measurement of the width & height.

Looking at their catalog of weatherstrip in the store, you'll see a shape picture, dimensions, and often common uses listed.

Same basic style & size will work, even if not identical.

They'll sell you official weatherstrip cement as well, since except for odd places like the extra piece at the bottom of our doors MOST is glued on.


sailor 03-19-2013 08:25 PM

FWIW - "Factory" or "Reproduction" pieces of weatherstrip are the easiest to use & give the best results simply because they are "pre-fitted" with the correct bends, sometimes even welded or connected in a loop for the best fit. Bulk rolls are cheaper, but installation will be more involved & a bit tedious if you are to get acceptable results.

Plan on at least one "gooey" finger, when dealing with the cement you need to spread it on both parts - let it "tack up" - then carefully place the weatherstrip. I like to reserve an index finger for spreading, then DON'T touch anything else with it! Practice a way to hold the strip glue side up before starting (like with some weights on a piece of cardboard). Otherwise it's likely to curl around & get stuck to everything nearby!

Hope this helps.....

whynotthinkwhynot 03-20-2013 05:02 AM

Try our vendor "Village Ford" <-- linky and see if they have factory weatherstrip. We get big discounts from them, so hopefully you can get the part you need.

All times are GMT -5. The time now is 08:26 PM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.