ABS sensor test with meter? - Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum
Ford Focus Forum
HomeContact UsAbout UsGalleryDiscussion ForumsMarketplace


Go Back   Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum > Ford Focus Tech Discussions > General Technical Chat

General Technical Chat This section is for technical discussions relating to general maintenance, electrical issues, engine trouble, and recalls.

Search This Forum | Image Search | Advanced Search    
FocusFest FocusFanatics Merchandise

Reply




 
LinkBack Thread Tools Display Modes
Old 10-09-2009, 08:01 PM   #1
Focus Enthusiast
 
Join Date: Sep 2009
Fan#: 69193
Location: Greencastle, PA
What I Drive: 2002 Red Focus SVT

Posts: 65
Points 1,046, Level 17
Points: 1,046, Level: 17 Points: 1,046, Level: 17 Points: 1,046, Level: 17
Level Up 46% Completed
Level up: 46% Level up: 46% Level up: 46%
Forum Activity 2%
Activity: 2% Activity: 2% Activity: 2%
FF Reputation: 1 boatingfool Good Standing Member
Buy-Sell-Trade Rating: (0)
ABS sensor test with meter?

My Haynes manual states I can check my ABS sensors with a volt meter by connecting the meter, reading VAC and spinning the wheel. Either this is bogus or I have 4 bad sensor/wheel bearings.

I recently replaced all 4 wheel bearings and I have the ABS light. See other post.

4 wheel bearings now ABS light....

Thanks for any info

Vincent


boatingfool is offline  
    Reply With Quote Quick reply to this message
Sponsored Links
Advertisement
 
Old 10-09-2009, 08:27 PM   #2
фанатик
 
roosterst's Avatar
 
Join Date: Dec 2008
Fan#: 61461
Location: Somewhere, PA
What I Drive: '05 CD silver ZX3 ST

Posts: 5,054
FF Reputation: 77 roosterst Excellent Standing Member
Buy-Sell-Trade Rating: (14)
How fast are you spinning the wheel? Was the ABS light on before replacing the bearings?
__________________
FR valvebody, 91 tune = 16.296 @ 84.08mph
roosterst is offline  
    Reply With Quote Quick reply to this message
Old 10-09-2009, 08:39 PM   #3
Focus Enthusiast
 
Join Date: Sep 2009
Fan#: 69193
Location: Greencastle, PA
What I Drive: 2002 Red Focus SVT

Posts: 65
Points 1,046, Level 17
Points: 1,046, Level: 17 Points: 1,046, Level: 17 Points: 1,046, Level: 17
Level Up 46% Completed
Level up: 46% Level up: 46% Level up: 46%
Forum Activity 2%
Activity: 2% Activity: 2% Activity: 2%
FF Reputation: 1 boatingfool Good Standing Member
Buy-Sell-Trade Rating: (0)
I don't know the exact speed I was spinning, but it was by hand and pretty fast. The meter didn't budge. I tried the left front which is a new bearing (black ring inboard towards sensor) and on the right rear wheel which the bearing and hub was purchased preassembled from Ford (Trousley). Spinning by hand with the wheel installed as fast as I can and the meter didn't change.

If I read for ohms across the sensor, I only get a reading if I put the probes on a particular way, almost like it is a diode.

The ABS light wasn't on before I started the project. I removed/inspected all 4 sensors, installed, no visual damage. I checked all 4 connectors, connected.
I drove the vehicle after replacement. I tried disconnecting the battery before, but it didn't didn't reset. I tried again tonight, but nothing.

Vincent
boatingfool is offline  
    Reply With Quote Quick reply to this message
Old 10-09-2009, 08:46 PM   #4
Focus Enthusiast
 
jarchie's Avatar
 
Join Date: Nov 2007
Fan#: 51811
Location: Charlotte NC, NC
What I Drive: 2010 Midnight Black SES 4-Door,

Posts: 298
FF Reputation: 5 jarchie Good Standing Member
Buy-Sell-Trade Rating: (0)
Send me your OHM readings. Do you have traction control? They use a different kind of sensor that will not produce voltage readings. pm me and I will try to help.
__________________
If you can make it go, I can make it go faster.
SEDAN REVOLUTION MEMBER #72 TEAM DURATEC #30
FORD F.A.C.T. INSTRUCTOR, FORD TRAINING CENTER INSTRUCTOR, TECHNICIAN. LOVER & OWNER
jarchie is offline  
    Reply With Quote Quick reply to this message
Old 10-09-2009, 08:46 PM   #5
фанатик
 
roosterst's Avatar
 
Join Date: Dec 2008
Fan#: 61461
Location: Somewhere, PA
What I Drive: '05 CD silver ZX3 ST

Posts: 5,054
FF Reputation: 77 roosterst Excellent Standing Member
Buy-Sell-Trade Rating: (14)
Can you measure how big the gap is between the tone rings, and the sensors?
__________________
FR valvebody, 91 tune = 16.296 @ 84.08mph
roosterst is offline  
    Reply With Quote Quick reply to this message
Old 10-09-2009, 08:49 PM   #6
Focus Enthusiast
 
jarchie's Avatar
 
Join Date: Nov 2007
Fan#: 51811
Location: Charlotte NC, NC
What I Drive: 2010 Midnight Black SES 4-Door,

Posts: 298
FF Reputation: 5 jarchie Good Standing Member
Buy-Sell-Trade Rating: (0)
By the way, on parts like these, i always go OEM.
__________________
If you can make it go, I can make it go faster.
SEDAN REVOLUTION MEMBER #72 TEAM DURATEC #30
FORD F.A.C.T. INSTRUCTOR, FORD TRAINING CENTER INSTRUCTOR, TECHNICIAN. LOVER & OWNER
jarchie is offline  
    Reply With Quote Quick reply to this message
Old 10-09-2009, 09:18 PM   #7
Focus Enthusiast
 
Join Date: Sep 2009
Fan#: 69193
Location: Greencastle, PA
What I Drive: 2002 Red Focus SVT

Posts: 65
Points 1,046, Level 17
Points: 1,046, Level: 17 Points: 1,046, Level: 17 Points: 1,046, Level: 17
Level Up 46% Completed
Level up: 46% Level up: 46% Level up: 46%
Forum Activity 2%
Activity: 2% Activity: 2% Activity: 2%
FF Reputation: 1 boatingfool Good Standing Member
Buy-Sell-Trade Rating: (0)
The car does not have traction control.

The front wheel sensors read 3.625mohms/3.680mohms. I don't remember what the rears were and I just cleaned up for the night (frustrated) .

I will check the rears tomorrow.

Again, I am only able to ohm the sensor if I have the test leads oriented one direction. If you reverse the leads, it reads open.

Thanks for the help.

Vincent

Oh, the front bearings were CFM but Ford OEM. The 2nd set of front I have to install were purchased from Trousley and are the same exact ones. I checked the black ring and it has a slight magnetic field. I removed the driver's side sensor and placed a ferrous tool (Snap on pick) and the wheel sensor ring pulls at the pick.
boatingfool is offline  
    Reply With Quote Quick reply to this message
Old 10-10-2009, 09:11 AM   #8
Focus Enthusiast
 
Join Date: Apr 2006
Fan#: 34025
Location: WNY, United States
What I Drive: 2001 Amazon Green ZTS, 2012 SE Seda

Posts: 287
FF Reputation: 9 drjkel Good Standing Member
Buy-Sell-Trade Rating: (1)
Hall-effect sensors can't be tested the same way the older-technology tone-ring (relucator) and coil systems can be tested with a volt meter. I get zero volts on my voltmeter from all four of my ZTS's sensors while spinning the wheels (fast) (w ABS & traction) and both systems work fine.
drjkel is offline  
    Reply With Quote Quick reply to this message
Old 10-10-2009, 03:18 PM   #9
Focus Fanatic
 
Join Date: Apr 2005
Fan#: 21700
Location: Iowa
What I Drive: 2005 Infrared ZXW

Posts: 3,737
FF Reputation: 109 penguin Excellent Standing Member penguin Excellent Standing Member
Buy-Sell-Trade Rating: (0)
Well, it also depends on the sensitivity of your meter. What AC range is it set to?

And, as someone said, if it is a hall effect sensor, rather than an inductive pickup type, the AC voltmeter test probably will not work.

I don't know which type the Focus uses, hall effect or inductive coil.
penguin is offline  
    Reply With Quote Quick reply to this message
Old 10-10-2009, 09:16 PM   #10
Focus Enthusiast
 
jarchie's Avatar
 
Join Date: Nov 2007
Fan#: 51811
Location: Charlotte NC, NC
What I Drive: 2010 Midnight Black SES 4-Door,

Posts: 298
FF Reputation: 5 jarchie Good Standing Member
Buy-Sell-Trade Rating: (0)
At Ford, we refer to them as Active and Passive. Passive sensors are tested with an OHM meter and can be tested to see if they produce AC voltave (in milivolts) and Active require a 12V power source and are tested in AMPS. Your meter has to be wired in series with the negitive lead from the sensor to the module and the positive wire has to be complete with the key on. The signal should toggle from 7mA to 14mA. If you are in Charlotte NC week after next, I am teaching Advanced Brakes.
__________________
If you can make it go, I can make it go faster.
SEDAN REVOLUTION MEMBER #72 TEAM DURATEC #30
FORD F.A.C.T. INSTRUCTOR, FORD TRAINING CENTER INSTRUCTOR, TECHNICIAN. LOVER & OWNER
jarchie is offline  
    Reply With Quote Quick reply to this message
Reply

Bookmarks & Social Networks

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
What I Drive
Year, color, and model of your car. Example: 2003 Pitch Black ZX3
Name
Your real name.
City
State
Country
Insurance
Please select your insurance company (Optional)

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 09:54 PM.


Copyright 2002-2015 FocusFanatics.com. All Rights Reserved : Privacy Policy : Advertise Information

Focus Fanatics Ford Focus Forum offers many fun ways for you to engage with other Ford Focus Owners from across the world. Whether it be about the aftermarket performance modifications, technical how-to's, European tuned suspension or awesome fuel economy similar to the Mazda CX-3, Audi S3, Mazda MX-5 Miata and Acura TLX. You can find all Ford Focus, Focus ST and Focus RS related information here. Join our Ford Focus discussion forums and chat with local Focus enthusiasts in your area. If you own other makes have a look at Challenger Hellcat Forum, Charger Hellcat Forum, Cadillac ATS-V Forum, Cadillac ATS Forum, Cadillac CTS-V Forum, Lexus RC-F Forum, Lexus GS-F Forum, Mercedes GLA Forum, Mercedes GLE Forum, Civic Type-R Forum and Volvo XC90 Forum.





Search Engine Optimization by vBSEO 3.6.1