Ecoboost 2.0 internals x Duratec 2.0 internals
I was wondering about the Ecoboost 2.0 internals into Duratec 2.0 block.
Is there any thread about this? The Ecoboost internals are more resistant and the engine has same bore x stroke of Duratec. I don't know about the rod jornals but I imagine it's same as Duratec, 50mm I think.
I think this engine can run 300whp safely, the ST has 252hp.
Your far better off running the eagle rods and forged pistons , if they did the ST the way they did the Mazda boost engine it had a steel crank but the mains and rods were not the same as the Focus engine , sense this is basically the Mazda engine I would guess your going to run into the same thing
You're right Tom.
Internals are very different. I ordered just only one rod from Ford. It's way bigger than the stock 2.0 rod. It's longer and stronger. I think it's about 10mm longer. It looks like Ford used the long block for this 2.0 ecoboost.
The crankshaft journal and piston pin are also bigger.
|All times are GMT -5. The time now is 10:12 PM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.1
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.