Focus Fanatics Forum banner

*Increasing* camber on non-lowered Focus

1K views 2 replies 3 participants last post by  thefrush 
#1 ·
I have a 2003 ZX5 into which I will install an SVT suspension set.

I also want to put in camber adjusters. However I probably want to *increase* camber to improve handling (and fine-tune handling balance), not reduce it because the car is slammed.

Do the rear camber bolts and front camber plates out there allow you to *increase* camber?

TIA
 
#2 ·
The Speciality Products front camber plates let you add an extra -1* of camber up front.
 
#3 ·
Control arms also allow you to adjust camber. Or you can just get coil-overs, and have a full range of adjustment.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top