|
joene2004 11-01-2005, 06:34 PM hey i dont know what vaccum line to tap into, i got a ford racing guage it came with this shitty little line..it fits right into any rubber vaccum line, but all the vaccum line is plastic it looks like except for the egr line but it has no vaccum..... someone please help Axman 11-01-2005, 07:22 PM anyone is fine, if you can get one coming off the intake manifold that works.. also get a T from an auto store and some extra hose and make sure all the connections are tight or you'll have a few problems joene2004 11-01-2005, 09:49 PM yea, those lines are tiny plastic line i can tee off of them ZetecZX3 11-01-2005, 10:10 PM This is where I put mine.... Pull off the vacuum fitting off the black cylinder type looking thing connected to the firewall, right behind the passenger side coolant reservoir. Mine had gray connector, then just put a 1" vacuum tube on the end where it connects, then put a tee in, and connected old gray to one end of tee, and the gauge line to other.. Axman 11-02-2005, 06:38 AM thats about where i hooked mine up. trahma 11-02-2005, 09:23 AM The general consensus is to tap into your fuel pressure regulator line. If you have issues with the T, this is the one that will be affected the least. 1turbofocus 11-02-2005, 09:41 AM I would NOT tap into the fuel rail PSI sensor line , this line needs to be for fuel ONLY , If the FRPS Vac line was to come off there would be no signal and bad things could happen Use the EGR Vac line or the EVAP pictured above Tom | |