08-22-2005, 12:49 PM
ok i know this is prob in the wrong place but, i need help with choosing the best clutch/pressure plate and flywheel combo for my boosted 2000 zx3. im going to be swaping to the mtx-75 insteas of the auto thats in it right now as soon as i get these last few pieces, but i wanna get the good stuff now instead of wasting my time with stock parts and ruining them and end up spending more in the end, so what would be the best for my 200-220 hp foci?
i heard that maybe the clutchnet flywheel would be better than the fidanza, cause the fidanza maybe to too light. and i was looking at spec clutch/pressure plates but i dont know what stage or what is best for the foci . who makes the best for it?
08-22-2005, 01:02 PM
Spec Stage 2 should be find if you do not plan on uping the boost to make more power.
08-22-2005, 01:17 PM
well i plan to up boost after i finish project so i was looking at a stage 3 that should be plenty for my purposes for now that is. but i was most concerned about the flywheel i heard the fidanza could be too light and cause stalling when stopping, someone they they practically had to relearn to drive the car but the clutchnet one is 3 lbs heavier and he got that one and its good now, so i dont know what to get just looking for lots of opinions, any ideas of whats the best any other brand to look at?
08-22-2005, 01:32 PM
I know Toms says the fidanza is a good combo for his kit,but I would get the cluthnet F/W only because its heavier but still lighter then stock
08-22-2005, 01:50 PM
ok sounds good thats what i was thinking anybody else got any input? just wanna get some info before i make this decision
08-22-2005, 06:41 PM
I like the Fidenza or the Clutchmasters Fly as well as the STG4 Clutch
08-23-2005, 01:00 PM
do you think the stage 4 would be a little over board for me , running 220 hp would like to go to 300 hp in future. do you know how much the clutchmasters flywheel weighs?
08-23-2005, 04:54 PM
I run the Clutchmasters stage 4 kit, and the Fidanza Flywheel with zero problems[thumb]
According to Fidanzas website the flywheel for an SVT is about 8.5#'s , I would believe the ZX3 version should be within a couple of pounds