04-12-2012, 09:46 AM
He NEED HELP on titanium dont start and
Have remove motor and battery FOR 14 days for body repair and put back in and dont start, put the obdII on and tell me no communication. The screen over the stering said ENGINE MALFONCTION SERVICE NOW He check fuse same all god but not able to start and the motor starter dont crank he try to jup the starter diect with the swich on and it turn but not with the push button start
before he remove the engine was running fine , the syn, radio, flasher, run [read]
04-12-2012, 09:50 AM
make him pay for you to take it to ford.. obviously he doesnt know what he is doing.
04-12-2012, 10:28 AM
If you have no Com. with the OBDII port then your PATS is more then likely set , with key on do you have ------- in the ODO ?
04-12-2012, 04:38 PM
is there an anti theft system on the focus?
04-12-2012, 06:30 PM
yes but on TITANIUM when you have key in car the cadran come on but not start
04-12-2012, 06:43 PM
OBD2 say: communication error
HE TRY 2 OBD2 AND 1 SNAP ON OBD2 ALLL THE SAME THING
04-12-2012, 09:29 PM
Sounds like either a ground wire off , ECU fuse bad (2 of them) or you have set the PATS
04-13-2012, 08:34 AM
thank 1turbofocus he gone check for fuse AND GROUND WIRE egain what is the PATS HE CANT CHECK OR WHAT TO DO HE CAN PATS CAN BY MADE
04-13-2012, 07:00 PM
PATS= Passive Anti-Theft System
04-26-2012, 12:42 PM
the car is at ford dealer and try to communicate with ecm and no communication any one know somethink or wiring diagram focus 2012 titanium
04-26-2012, 12:47 PM
i remember seeing a thread where this happened to someone.. ended up being a faulty computer..
04-26-2012, 01:00 PM
THANK drunkyoda HE WILL KNOW THIS WEEK AND TELL TOU MAY BE WATH WAS DEFECT
04-26-2012, 05:22 PM
There are 3 small ground wires at the Batt that have to be connected , and a few that go to the Fuse box , are you sure that all grounds are connected ?
04-26-2012, 06:04 PM
my focus is at for dealer and have enter manuel the vin
the serial of the ecm and askinf for the lige configuration can you tel me he can find this configuration of ecm
thank Elder 1turbofocus
04-26-2012, 06:45 PM
I am not sure what your asking there ?
04-26-2012, 06:48 PM
lol ummm use spell check mang..