07-08-2011, 04:59 PM
Would 1.5 be an ok spot to put the bung till i can afford a better exhaust?
Where is everyone else putting theres on a duratec 2.0 with manicat?
07-08-2011, 06:58 PM
Yes that will be a good spot
07-09-2011, 02:23 AM
Hey that last file was the best one so far! I think this is the best its ran since i got it! Thanks
07-09-2011, 03:53 PM
When i take the wideband 02 out of the last bung should i plug it? or put the stock 02 back in?
I read in the innovate manual that its not good to run the sensor in the pipe if its not hooked up. Somthing about the heater needs to be hooked up and heating or it would ruin the sensor. Not sure if the stock ones are like this or not?
Right now Tom has the last sensor turned off, but does that mean its just not sending data? or not heating either?
Ill need to plug the hole either with the stock sensor or a plug.
07-09-2011, 03:56 PM
Either sensor or plug wont matter
07-09-2011, 06:23 PM
The local muffler shop wont do it. They said they cant weld into cast iron.
They said the manicat would have to come off and if i went threw all that ide just have a header put on insted.
Looks like thats my next step.