Hey guys, was hoping someone could tell me what interface cable i require, as i just purchased PCMSCAN (http://www.palmerperformance.com/products/pcmscan/index.php)

My car specs as follows..

Year/Make/Model
2007/FORD/LT FOCUS 2.0L HATCH

Thanks for your help.

Would i require a "OBDII V1.3 USB Interface Cable" (ELM327?) which supports CAN bus?

If so, would this be the right one? EBAY:USB Diagnostic Interface V1.3 Cable (http://cgi.ebay.com.au/CAN-EOBD-OBD2-OBD-2-Diagnostic-Interface-Auto-Scanner-/190404694648?cmd=ViewItem&pt=AU_Car_Parts_Accessories&hash=item2c55011278)

bump

Would i have access to all related sensors and system tests?

From what I understand, and correct me if i am wrong, the Ford focus is on PWM but the OBDII protocol supports very small amount of commands.

Why not just get a XCAL3 so you can check CEL , datalog , and flash tunes to your car

Tom

because i was hoping to do all that besides the flashing over a $25 cable, instead of shelling out $600+