Ok so I'm not sure if this goes in this section so mods move as needed...


So I made a boo boo. I was hooking my J&S gauge up to my firewire cable to datalog. so I bought a splitter rca jack to split the signal. I plugged in the cable into my J&S and the way I have my J&S mounted and the actual weight of the cable ::sigh:: actually pulled the J&S femal jack/hookup out of the circuit board.

I can see two tabs that are supposed to be secured in the board. I was able to fanagle it and could get a signal if I held it in place but... I believe it needs to be taken apart and re-solderd(SP) back together.


I emailed J&S saterday and havn't gotten a response yet. it's only noon on monday so I don't expect anything just yet but I wanted some input. if anyone knew what they would charge? hourly rate? OR if anyone believes this could be a fairly easy fix?

thanks guys....Hope I can get this done fast cause I would really like to go back to tuning my car... urrr.

You did right contacting J&S , they wouldnt charge much for repair , I would box it and ship it today , John has been kind of buisy but is a great guy and will take care of you

Tom

I'm hoping to talk to someone before I ship...anyone know the hours of when would be a good time to call?

Managed to call john and talked to him. Great guy to talk to super friendly and helpful. I'll be sending my J&S off tomorrow to have it fixed. yippie!!

There you go !

Tom

he is a real nice guy I think it was $45 to get mine repaired