08-17-2009, 07:55 PM
I'm not sure if this is the right area to post this so if it isn't please move. I'm looking for a How-to for a wire tuck for a Zetec engine bay. If anyone knows where to find one i will give rep. points.
08-17-2009, 09:12 PM
These are all duratec's (just a complete mess of an engine bay):
I think there has been a little talk on the zetec cars but I can't recall any full on thread about it. Also being as technical and picky as wiring is I don't think there should ever be a how-to on it.
Pretty much pull the inner fenders and route what you can back there. You'll have to extend wires so supplies will be soldering iron, solder, flux, heat shrink, tape, etc. and make sure the wiring in the fenders is secure and well protected.
If you know nothing about wiring, don't even think of attempting it.
08-17-2009, 09:27 PM
agreed, I wouldn't even think of attempting this unless you are experienced. But I guess if you have something else to drive and your feeling gutsy....