|
sporadic 03-27-2009, 01:03 PM I'd like to add an IAT sensor to my 2006 Duratec. My understanding is it typically gets wired in with the MAF. Which wires for the Duratec get used? Are people using the Lightning IAT sensor? Blivit 03-27-2009, 01:28 PM I'd like to add an IAT sensor to my 2006 Duratec. My understanding is it typically gets wired in with the MAF. Which wires for the Duratec get used? Are people using the Lightning IAT sensor? Your car already has one stock. If you are trying to add a second one, you will not be able to monitor it using the factory ecm. sporadic 03-27-2009, 01:37 PM Oh ok, that's convenient and unexpected! Thanks Blivit! Blivit 03-27-2009, 01:42 PM Oh ok, that's convenient and unexpected! Thanks Blivit! On newer vehicles it is part of the maf (6 wire setup.) If you wanted to, you could take the 2 wires that are for the IAT out of the maf and get an extra sensor like the lightning one and wire it in. That way you could then put that sensor wherever you wanted to. sporadic 03-27-2009, 01:46 PM I might actually do that since I'm running a draw-through MAF. So now that I think about it it's not all that convenient unless I switch to a blow-through setup. Which wires are for the IAT? Blivit 03-27-2009, 02:02 PM I might actually do that since I'm running a draw-through MAF. So now that I think about it it's not all that convenient unless I switch to a blow-through setup. Which wires are for the IAT? According to alldata it should be the first 2 pins on the maf connector. Pin 1 should be a white wire with a violet stripe and pin 2 should be a brown wire with a white stripe. Again, this is coming from alldata so it may or may not be correct. sporadic 03-27-2009, 02:05 PM Thanks, I'll check it out this weekend and confirm. Do you work for SCT? I'm trying to get access to the PRP forum.. my name is also "sporadic" there. Blivit 03-27-2009, 02:07 PM Thanks, I'll check it out this weekend and confirm. Do you work for SCT? I'm trying to get access to the PRP forum.. my name is also "sporadic" there. Yes I do. PM me your username and racer code on our forums and I can get you access. sporadic 03-27-2009, 02:10 PM Yes I do. PM me your username and racer code on our forums and I can get you access. Thanks for the help! You have a PM on your forum. I had to snail-mail my license agreement since I don't have a fax.. Blivit 03-27-2009, 02:15 PM Thanks for the help! You have a PM on your forum. I had to snail-mail my license agreement since I don't have a fax.. I actually have a different account there. Can you send the same message to MikeR@SCT? illinipo 03-27-2009, 04:47 PM me too me too!!! sporadic I was going to say why not just convert to blow through? but it looks like you know whats going on [thumb] | |