09-29-2008, 06:19 PM
I have a few charge air pipes that I need to clean up. One is metal dust from machine work(already tried blowing out with compressed air) and the other two have a lot of rust on the inside. Both pipes are too small in diameter to fit my hand in, and neither are straight. Any good ideas? Thanks.
09-29-2008, 06:30 PM
But a wire around some shop rags so it is tight and pull the wire through , this will clean them , I have 2 one to get the worst then another for final cleaning
09-29-2008, 07:28 PM
You put enough shop rags together so it is a pretty tight fit in the pipe and then pull it through? Do you spray any type of cleaner or anything inside the pipe before doing this?
09-29-2008, 08:32 PM
Yes the rags pulling through are tight , You can use some cleaner if you choose