05-01-2008, 02:43 PM
I'd like to install electric oil pressure gauge but having troubles where to put sender. There is no access to rear side of engine block due to SC, I tried location behind coil pack but there isn't enough place either. Can I install it into oil filter relocation adapter? Will I get correct readings?
05-01-2008, 03:42 PM
Yes you can get what they call an "oil sandwich"
05-01-2008, 04:52 PM
can i get fries with that? jk i've never heard that term b4 i'm curious what is it?
05-01-2008, 05:22 PM
Looks like this http://www.glowshiftdirect.com/ProductImages/accessories/OILCOOLERADAPTER.jpg
PW kit has an oil filter relocation kit but there are no 1/8 NPT ports for senders in it. But on remote part of that kit is 2 big probably 3/8 NPT ports with plugs. I'm thinking if I can somehow use those. Will I get correct reading there?
05-02-2008, 12:45 AM
i am using a mechanical gauge and i just put it in the stock port with a tee for the stock one there is room u have to remove the drive shaft and the bracket and the oil filter relocation adapter its kinda a pain i did it on a lift though so it was kinda easier just use ample amounts of sealant