i wanted to make sure this is the right way to set this up before i go cutting up my charge pipe.

http://i17.photobucket.com/albums/b97/mrs_steed/100_0396.jpg

http://i17.photobucket.com/albums/b97/mrs_steed/100_0395.jpg

thanks,
tim

Correct BOV>>> MAF>>>>> TB

Put your MAF on the housing and make sure you weld it on going the right direction , you can put the BOV anywhere , try to center the MAF right in the milddle of that long piece of pipe

Tom

there isnt really any place else in the cold side of the intercooler piping to put the bov. that is the only peace of pipe that is straight enough. i cant tig weld and dont have any access to a tig welder so i need enough room to put a coupler.

http://i150.photobucket.com/albums/s98/tls_zx3/100_0404.jpg

No... Dont do it with hoses , find a local weld shop and have everything cut and ready to go , use a marker and when you have everything like you want it put lines on the piping so when you get to the welding shop they can put it back to weld it exactly like you had it on the car and again make sere the MAF is going in the right direction

If your going to do it do it right the first time , it cost more to do it the second time

Tom

i agree with tom....

see the first bend after the first straight section, i would get a flange and have it welded on that little straight section.

ok that is what i will do. and dont worry i know about the maf, lol. and plus it will look better to have it welded any way. thanks tom

im having this welded in like this tomarrow. and i will start converting my car over monday! yay im so excited, lol

http://i150.photobucket.com/albums/s98/tls_zx3/100_0432.jpg

http://i150.photobucket.com/albums/s98/tls_zx3/100_0426.jpg

and once i get the intercooler and piping in i will have the bov adapter welded in here....

http://i150.photobucket.com/albums/s98/tls_zx3/100_03962.jpg

but i have to wait so i know that i have the angle right and that it will fit.

http://img207.imageshack.us/img207/9053/1000396ht1.th.jpg (http://img207.imageshack.us/my.php?image=1000396ht1.jpg)

Would that work?? (what i would do...but i cannot see the angle very well with the pic so it might not be able to happen..although if your welding and cutting you can always cut the bov adapter a little shorter.)

Either should work.... my BOV is closer to the MAF than that...

http://i5.photobucket.com/albums/y173/OrangeSVT03/SSF1.jpg

i can not put it in that second bend because it will not fit in the car. it is to tight of a fit there. that is pretty much the only spot i can put it and it will still be a tight fit.

maf is installed but the welder wasnt there today so i will have him do it tomorrow. but here is a pic of it so far...

http://i150.photobucket.com/albums/s98/tls_zx3/100_0455.jpg

That should work great

Tom