p0352 code after coil,plugs, and wires
Hey all, I have a 2003 Focus SE with a 2.0 vin "p", 230K miles. It was running rough, bucking at low rpms while driving at highway speed, so I did a tune up. New coil pack, new wires, and plugs. Gapped the plugs to the spec on the sticker in the engine compartment. Now, it barely runs without stalling, and is kicking up p0352 code, and cylinder 1 misfire code. It was just running rough at first, but then kicked up a cylinder 1 misfire code, nothing else, so i figured it to be ignition. Ive triple checked the wires are on the correct coil post. The plug harness going into the coil appears fine, no cracked or loose wires. Im at a loss here. Any ideas?