Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Sneak Peek of Ken Block's Widebody ST Project
View Single Post
Old 02-06-2013, 12:45 PM   #23
Focus Rookie
Join Date: Feb 2013
Fan#: 109588
Location: Los Angeles, CA
What I Drive: 2013 Focus ST

Posts: 6
FF Reputation: 1 brad@fifteen52 Good Standing Member
Buy-Sell-Trade Rating: (0)
Originally Posted by Kevastator View Post
If they did a full production run of these, I bet some of the guys here on FF would eat them up
Originally Posted by Kevastator View Post
You don't have to rub it in, Lou jk

Do you guys have an in-house injection molding shop, or would you outsource it somewhere?

Don't go by me, (obviously haha) but I'm pretty sure people on here are going to light up as soon as we see them at more angles

Keep up the good work
We'd start out making parts in FRP (flexible fiberglass) due to the lower cost for small production runs. Plastic molds (injection or vacuum) are just too expensive at this point.
brad@fifteen52 is offline  
    Reply With Quote