Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Need help with finishing a bare metal surface
View Single Post
Old 01-30-2013, 03:20 PM   #11
Focus Addict
_fifth_'s Avatar
Join Date: Feb 2010
Fan#: 72683
Location: Louisville, KY
What I Drive: oh-sicks Silver ZX4

Posts: 939
Points 3,953, Level 40
Points: 3,953, Level: 40 Points: 3,953, Level: 40 Points: 3,953, Level: 40
Level Up 2% Completed
Level up: 2% Level up: 2% Level up: 2%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 6 _fifth_ Good Standing Member
Buy-Sell-Trade Rating: (3)
I wish I had seen that before I actually wet sanded it. It looked amazing but I could see the rust forming before my eyes after I dried it. I had to dry it and clear coat it immediately to stop it from rusting out any more. I'm going it give it a few days outside to see if the rust stops, but I have a feeling I'm going to have to start the whole process again, although the small rust swirls look kinda cool for the rat bike look I'm going for.
I have the feeling I will have to sand it all over again in a few days while I'm working on mounting the engine to the frame. BOOOOO
My name is Karyn! What's yours?
FocusXtreme - 502

Originally Posted by miragesmack View Post
Yeah, too many hatches. When the sedans take over, all will be good!
_fifth_ is offline  
    Reply With Quote