Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - CWCZX3's Built Motor Project
View Single Post
Old 12-16-2012, 08:20 PM   #291
Focus Addict
cwczx3's Avatar
Join Date: Sep 2003
Fan#: 852
Location: York, PA 17404, United States
What I Drive: 2000 Autumn orange ZX3

Posts: 573
Points 16,756, Level 82
Points: 16,756, Level: 82 Points: 16,756, Level: 82 Points: 16,756, Level: 82
Level Up 82% Completed
Level up: 82% Level up: 82% Level up: 82%
Forum Activity 1%
Activity: 1% Activity: 1% Activity: 1%
FF Reputation: 6 cwczx3 Good Standing Member
Buy-Sell-Trade Rating: (4)
Got the Eboost2 installed and wired up. this is how i have the vac lines to the solenoid hooked up.

Port 1 vents to atmosphere
Port 2 goes to the bottom port of the WG
Port 3 goes to a boost pressure source which is my vac manifold block. This is also where i get my signal to the controller itself.

I set everything to zero which should get me gate pressure which was @12 psi on the old setup with xs manual boost controller all the way closed. I hit @16 psi while out testing it so i'm not sure what's going on. Next i will run it with no controller installed to see what my actual gate pressure is.

So anyone else out there using the Eboost2 have any input?

2000 Autumn Orange ZX3 "Beauty"Weekend Toy
2013 Performance Blue STDaily
2001 Flat Black ZX3 "River Rat"SOLD
cwczx3 is offline  
    Reply With Quote