Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - "How To" SVT & Zetec Power Steering Pump & Line Replacement
View Single Post
Old 10-21-2012, 07:19 PM   #7
Focus Rookie
Join Date: Oct 2012
Fan#: 104842
Location: Los Angeles, CA
What I Drive: 2000 Red ZX3

Posts: 18
FF Reputation: 1 FLZ_Boy Good Standing Member
Buy-Sell-Trade Rating: (0)
I'm currently replacing the powersteering pump on my 2000 ZX3. I notice this post shows an O - Ring being placed in the union bolt hole on the power steering pump:

I looked through the factory service manual and didn't notice any O-Ring being placed there. Anyone replaced their power steering pump lately can elaborator on this??

Also, I tried using the new powersteering pump without the O-Ring and it leaks through the union bolt pressure line (attached to the bolt). The O-Rings supplied by the new pump did not fit in the union bolt hole. Or am I suppose to replace the the entire powersteering high pressure line??

FLZ_Boy is offline  
    Reply With Quote