Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Busted battery tray = project time
View Single Post
Old 10-07-2012, 09:30 PM   #1
Focus Enthusiast
gun_runner's Avatar
Join Date: Nov 2011
Fan#: 91693
Location: Monrovia, CA
What I Drive: 2000, Dirt Metallic, Kona ZX3

Posts: 253
Points 2,301, Level 29
Points: 2,301, Level: 29 Points: 2,301, Level: 29 Points: 2,301, Level: 29
Level Up 1% Completed
Level up: 1% Level up: 1% Level up: 1%
Forum Activity 1%
Activity: 1% Activity: 1% Activity: 1%
FF Reputation: 1 gun_runner Good Standing Member
Buy-Sell-Trade Rating: (4)
Busted battery tray = project time

My battery tray finally gave up the ghost so decided to make one out of 1/2" aluminum

Milled out some nice angled hold downs. The rear one is stationary, and the front one squeezes the battery between the two when you tighten it. Now this thing doesn't budge at all. I was going to pocket mill it 1/4 into the aluminum, but not all batteries are alike, so i just made it mount to the surface.

right now it is just band saw cut to the rough shape, but i am going to remove it soon to square and radius mill all the edges to make it a little more visually appealing. Might pocket mill the bottom to make it lighter too.

engine bay is starting to look less and less cluttered now that the battery tray, the power steering line, and air box are all gone. look carefully and you can see the stainless power steering line running the perimeter of the engine bay.

gun_runner is offline  
    Reply With Quote