Originally Posted by Power Surge
Here's the problem with PRYING the bezels out from the front....
What holds them in is thin little U tabs formed into the bumper cover that snap into those slots in the bezel. If you don't release the tabs the correct way, you just rip the U in half by pulling them out through the front. Then you run the risk of them not snapping back into place correctly, because the tabs are broken.
Yes, I'm with Power surge all the way. Your way is easier but a screwdriver?
There's a right way, a wrong way, and a large grey area in between.
At least use a plastic pry tool!
2012 SGM SE 4 door-5 spd,SE Sport
2010 SGM FX4 F150 Lux,Flowmaster catback,2.5" level,sat-nav,305/55/20,HD grille,heads,&tails,Jon Lund SCT tune
2005 SB ZX3 SE 5MT
1993 Mustang Featured in MM/FF and 5.0 and Super Ford Magazine SOLD - 2003 Cobra SOLD