Originally Posted by tjboston5676
so i did this today and was able to get the tach and speedo needles almost perfect (they were way off to begin with) but i cannot get the fuel and temp to work right it doesnt matter where i put the needle it just drops down a little bit and when i turn the car off they dont move back down on their own and they are not rubbing i dont think, and if i push them down to off position when i turn the car back on they barely move at all
did i screw them up or what?
Tjboston. Make sure you don't push the needles down too far. Also in the test mode when you hold down the odometer needle sweep the gauges and make sure they move all the way. Like miragesmack make sure the tank is full and run the car a while and put the temp needle in the middle. How do the gauges look?