Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - HOW-TO Install Shift Knob/Boot on ATX
View Single Post
Old 08-21-2008, 11:38 AM   #73
Focus Fanatic
bluefront's Avatar
Join Date: Jun 2008
Fan#: 56816
Location: St Louis Missouri USA, MO
What I Drive: 2006 white ZX5 SES

Posts: 3,487
FF Reputation: 146 bluefront Excellent Standing Member bluefront Excellent Standing Member
Buy-Sell-Trade Rating: (6)
Update....after looking at the setup for a while I didn't like the way the boot fit. It seemed to be a little long. So I cut the bottom elastic off and shortened the whole boot about an inch. Fits better. I also removed the lace from the top. To get the top to hold tighter, I ran a thin strip of cloth duct tape around the top edge. I like it much better, and the shifter moves easier...about like it did without the boot.

The foam gasket is now necessary to hold the boot tight. This should do it..

bluefront is offline  
    Reply With Quote