Originally Posted by FSUFocus
Can you send me the measurements for the mani? What there someone @ JGS that might still have them available? I gotta say that's one mean set up. I've caught the FI bug bad.
Actually that would be a hassle for me at the moment.
I already have the manifold wrapped and it's a bit of a pain.
I'm sure JGS still carry the manifold and they also sell them pre-welded.
edit: Tomorrow I can take a couple measurements of the "log" section of the manifold if you like without unwrapping the header..
However, the location of the radius plate /T3-flange for my exhaust outlet will almost certainly not be the same place anybody else's is located.
I clearly took the tough route and started with a turbo that wasn't very generic, and had to fab both the exhaust elbow and ambient inlet.
I want to be as much help as possible, but know there are aspects between custom builds that will not match, and the parts I mentioned are big.
About the only thing common between my build and someone else's will be the basic "log" of the manifold.